3com database adapter module for networker nsr-ora v3.2 User Manual

System Administrator’s Guide

U42252-J-Z915-1-76

The following chapter describes the installation and configuration of NSR-ORA.

This section gives experienced users an short overview of all steps required to 
install and configure NSR-ORA. It is a synopsis of the information presented in 
this chapter and the rest of the manual and is intended to help you to get NSR-
ORA “up and running” quickly and easily.

In order to install NSR-ORA and prepare it for use you need to carry out the 
following steps:

1. Install NSR-ORA on the database computer (Enabler and NSR-ORA pack-

age) using the relevant command for the respective platform. Refer to the 
sections 

 and 

2. Now start the database (with startup or, in the case of OPS, with startup 

) so that configure_nsrora can determine the tablespace names.

3. Call up the configure_networker tool and fill in the informations described in 

.

4. Make sure that you have NSR administrator rights.

5. Call up the configure_networker tool (refer also to the section 

When using a NetApp filer in order to perform NDMP-backups, you may 
have to define some NetWorker ressources manually (see 

6. Specify the Start time for the database group in NetWorker and set the 

attribute Autostart to Enabled (for further information, please refer to your 
NetWorker documentation).

7. Highlight the required data carriers for the database and the archiving 

monitor amon (see the manual NetWorker - Installing, Configuring and 
Operating

).

8. Make sure that the database is in the archive mode using the command 

.