3com 3CRWE875075A User Manual

19

To link the access point to your Ethernet network, plug one end of another 
Ethernet cable into the port labeled To Hub/Switch on the power supply, and plug 
the other end into a LAN port (on a hub or in a wall).

If your LAN equipment complies with the IEEE 802.3af power-over-Ethernet 
standard, you can connect the access point directly to a LAN port. For example, the 
illustration above right shows a connection through a 3Com Ethernet Power Supply to 
a 3Com SuperStack

®

 Switch.

When power is connected, the access point LEDs light. The illustration and the 
following table describe the LEDs and their functions.

The access point comes equipped with all the necessary hardware for mounting on a 
wall, including a mounting plate. For a secure installation, the mounting plate should 
be placed perpendicular to the floor, with the arrow pointed up, as indicated on the 
mounting plate, with the smooth side against the wall.

Radio

LED blinks red to indicate radio activity. Faster 
blinking indicates more activity.

Power

LED lights green when operational code 
is running.

Reset 
Button

Press this button and hold for 15 seconds to restore 
the factory defaults.

Ethernet LED lights yellow when Ethernet link is 

established. LED blinks to indicate activity on the 
Ethernet. Faster blinking indicates more activity.

Radio

LED blinks red to indicate radio activity. Faster 
blinking indicates more activity. (This LED is 
only active when a second radio is installed.)

Reset
Button