3com 3CRWE850075A User Manual

36

Although there are five types of IPX packets, the Filter Control page shows only two 
options for IPX filtering. The following table shows how to filter each IPX packet 
type: 

Use the SNMP page to display and enter a community string for the Simple Network 
Management Protocol. To communicate with the access point, the SNMP agent must 
first be enabled and the Network Management Station must submit a valid community 
string for authentication. Select SNMP Enable and enter data into the fields as 
described below. When you are finished, click Apply. 

n

Location—Specifies the access point location.

n

Contact—Sets the system location string that describes the system location. 
(Maximum length: 255 characters)

n

Community Name (Read Only)—Specifies a community string with read-only 
access. Authorized management stations are able to retrieve MIB objects. 
(Maximum length: 23 characters)

n

Community Name (Read/Write)—Specifies a community string with read-write 
access. Authorized management stations are able to both retrieve and modify MIB 
objects. (Maximum length: 23 characters)

n

Trap Destination IP Address—Fill in the IP address box for a trap manager that 
will receive these messages.

n

Trap Destination Community Name—Fill in the community string box for a trap 
manager that will receive these messages. (Maximum length: 23 characters)

The Administration page allows you to perform access point management tasks as 
described below. 

n

Change Password—A password is required to configure the access point. Enter 
the user name and new password in the spaces provided and click Apply. It is 

8138

Enable 8138

8137

Enable 8137

802.3(Raw)

Enable 8138

802.2

Enable 8138

SNAP

Enable 8137