3com 3CRWE825075A User Manual

27

You can only configure devices that are on the same subnet as your computer. To 
configure a device on a different subnet, you must first assign it an IP address on the 
same subnet as your computer. After you launch the configuration, you can change 
settings as usual. Just before you finish, you must change the device IP address back to 
its original setting. Follow this procedure:

In the Wireless Infrastructure Device Pre-IP Configuration window, accept the 
suggested settings or change them as required. You can assign a static IP address 
or specify that the device obtain its IP address from a DHCP server.

The next window prompts for an administrative password. When the units are 
shipped from the factory, there is no administration password and you should 
leave the password field blank. If an administration password has been set for the 
device, enter the password and click Next. The Configuration Management System 
main page appears in the Web browser.

After you launch the configuration from the device manager, the login page appears in 
your browser. The default Username is admin and the default password is no 
password. For an initial configuration, enter the default Username and click LOGIN. 
Then set the Country Code as described below.

The Country Code determines the available channels and transmission power level 
based on regulatory restrictions in the country where the access point is installed. The 
first time you log in, you must set the Country Code.

To ensure compliance with local regulations, be sure to select the country in which the 
access point is installed.

In the Country Code page, select the country from the pull-down list and click Apply. 
The Home page appears.