3com WX2200 3CRWX220095A User Manual
151
C
HAPTER
7: C
ONFIGURING
SNMP
This command configures target 1 at IP address 10.10.40.9. The target’s
SNMP engine ID is based on its address. The MSS SNMP engine will send
notifications based on the default profile, and will require the target to
acknowledge receiving them.
SNMP engine ID is based on its address. The MSS SNMP engine will send
notifications based on the default profile, and will require the target to
acknowledge receiving them.
The following command configures a notification target for
unacknowledged notifications:
unacknowledged notifications:
WX1200# set snmp notify target 2 10.10.40.10 v1 trap
success: change accepted.
success: change accepted.
Enabling the SNMP
Service
To enable the MSS SNMP service, use the following command:
set ip snmp server {enable | disable}
The following command enables the SNMP service:
WX1200# set ip snmp server enable
success: change accepted.
success: change accepted.
Displaying SNMP
Information
Information
You can display the following SNMP information:
Version and status information
Configured community strings
User-based security model (USM) settings
Notification targets
SNMP statistics counters
Displaying SNMP
Version and Status
Information
To display SNMP version and status information, use the following
command:
command:
display snmp status
Displaying the
Configured SNMP
Community Strings
To display the configured SNMP community strings, use the following
command:
command:
display snmp community
Displaying USM
Settings
To display USM settings, use the following command:
display snmp usm