3com WX2200 3CRWX220095A User Manual

To change transmit rates for a service profile, use the following 
command:

set service-profile name transmit-rates {11a | 11b | 11g}
mandatory rate-list [disabled rate-list] [beacon-rate rate] 
[multicast-rate {rate | auto}]

The following command sets 802.11a mandatory rates for service profile 
sp1 to 6 Mbps and 9 Mbps, disables rates 48 Mbps and 54 Mbps, and 
changes the beacon rate to 9 Mbps:

WX1200# set service-profile sp1 transmit-rates 11a mandatory 
6.0,9.0 disabled 48.0,54.0 beacon-rate 9.0
success: change accepted.

By default, the rate set is not enforced, meaning that a client can 
associate with and transmit data to the MAP using a disabled data rate, 
although the MAP does not transmit data back to the client at the 
disabled rate.

You can configure MSS to enforce the data rates, which means that a 
connecting client must transmit at one of the mandatory or standard 
rates in order to associate with the MAP. When data rate enforcement is 
enabled, clients transmitting at the disabled rates are not allowed to 
associate with the MAP.

auto for all radio types

Data rate of multicast frames sent by 
MAP radios. 

„

rate—Sets the multicast rate to a 
specific rate. The valid rates depend 
on the radio type and are the same 
as the valid rates for mandatory. 
However, you cannot set the 
multicast rate to a disabled rate.

„

auto—Sets the multicast rate to the 
highest rate that can reach all clients 
connected to the MAP radio.

Table 19   Transmit Rates (continued)