3com WX2200 3CRWX220095A User Manual

WX1200# set ap 69 radio 1 channel 7
success: change accepted.
WX1200# set ap 67 radio 1 radio-profile rfid-listeners mode enable
success: change accepted.
WX1200# set ap 68 radio 1 radio-profile rfid-listeners mode enable
success: change accepted.
WX1200# set ap 69 radio 1 radio-profile rfid-listeners mode enable
success: change accepted.

You can use an AeroScout Engine or 3Com Wireless Switch Manager to 
locate an asset to which an RFID tag is attached.

1 Load the site map in AeroScout System Manager.

2 Mark the origin point (0,0), if not already done.

3 Calibrate distance, if not already done.

4 Add each MAP configured as a listener to the map, and enter its IP 

address. 

5 Enable RSSI location calculation.

6 Enable tag positioning. 

7 Enable the map to use the MAPs.

To check the status of a MAP, right-click on the MAP icon and select 
Status.

If your network is modeled in a 3Com Wireless Switch Manager network 
plan, you can use 3Com Wireless Switch Manager to locate devices that 
have AeroScout asset tags. This capability requires the following:

„

Three or more listeners are required for optimal location results. 3Com 
Wireless Switch Manager will attempt to display a tag’s location even if 
there are fewer than three listeners, but the location might not be accurate.

„

The listener MAPs must be in the network plan, on the floor where 
the asset tags are located.