3com WXR100 3CRWXR10095A User Manual

C

HAPTER

 7: C

ONFIGURING

 SNMP

WX1200# set snmp notify profile snmpprof_rfdetect send 
RFDetectInterferingRogueAPTraps
success: change accepted.
WX1200# set snmp notify profile snmpprof_rfdetect send 
RFDetectInterferingRogueDisappearTraps
success: change accepted.
WX1200# set snmp notify profile snmpprof_rfdetect send 
RFDetectRogueAPTraps
success: change accepted.
WX1200# set snmp notify profile snmpprof_rfdetect send 
RFDetectRogueDisappearTraps
success: change accepted.
WX1200# set snmp notify profile snmpprof_rfdetect send 
RFDetectSpoofedMacAPTraps
success: change accepted.
WX1200# set snmp notify profile snmpprof_rfdetect send 
RFDetectSpoofedSsidAPTraps
success: change accepted.
WX1200# set snmp notify profile snmpprof_rfdetect send 
RFDetectUnAuthorizedAPTraps
success: change accepted.
WX1200# set snmp notify profile snmpprof_rfdetect send 
RFDetectUnAuthorizedOuiTraps
success: change accepted.
WX1200# set snmp notify profile snmpprof_rfdetect send 
RFDetectUnAuthorizedSsidTraps
success: change accepted.

A notification target is a remote device to which MSS sends SNMP 
notifications. You can configure the MSS SNMP engine to send confirmed 
notifications (informs) or unconfirmed notifications (traps). Some of the 
command options differ depending on the SNMP version and the type of 
notification you specify. You can configure up to 10 notification targets.

To configure a notification target for informs from SNMPv3, use the 
following command:

set snmp notify target target-num ip-addr[:udp-port-number] 
usm inform user username 
snmp-engine-id {ip | hex hex-string} 
[profile profile-name] 
[security {unsecured | authenticated | encrypted}]
[retries num]
[timeout num]