3com WXR100 3CRWXR10095A User Manual

C

HAPTER

 10: C

ONFIGURING

 MAP A

CCESS

 P

OINTS

The disconnected MAP can then begin the boot process again to find 
another WX switch that has an Auto-AP profile. When the MAP is 
disconnected, the MAP clients experience a service disruption, and will 
attempt to associate with another MAP if available to reconnect to the 
SSID they were using. If another MAP is not available to a client, the client 
can still reconnect after the disconnected MAP is connected to a new WX 
and finishes the boot and configuration process.

The Auto-AP profile for Distributed MAP configuration is like an 
individual MAP configuration, except the configuration has the name 
auto instead of a Distributed MAP number. 

To create an Auto-AP profile for automatic Distributed MAP 
configuration, type the following command:

WX1200# set ap auto
success: change accepted.

To display the MAP settings in the Auto-AP profile, type the following 
command:

WX1200# display ap <apnum> config auto
Dap auto: mode: disabled bias: high
fingerprint
boot-download-enable: YES
force-image-download: NO
Radio 1: type: 802.11g, mode: enabled, channel: dynamic
tx pwr: 15, profile: default
auto-tune max-power: default
Radio 2: type: 802.11a, mode: enabled, channel: dynamic
tx pwr: 11, profile: default
auto-tune max-power: default

This example shows the defaults for the MAP parameters you can 
configure in the Auto-AP profile. Table 16 lists the configurable Auto-AP 
profile parameters and their defaults. The only parameter that requires 
configuration is the Auto-AP profile mode. The Auto-AP profile is 
disabled by default. To use the Auto-AP profile to configure Distributed 
MAPs, you must enable the profile. (See “Enabling the Auto-AP Profile” 
on page 222.)