3com WXR100 3CRWXR10095A User Manual

  force-rebalance: NO,
  Radio 2: type: 802.11a, mode: disabled, channel: dynamic
  tx pwr: 17, profile: default
  auto-tune max-power: default,
  load-balance-group: ,
  load-balance-enable: YES,
  force-rebalance: NO,
  local-switching: enabled, vlan-profile: locals

(For information about the fields in the output, see the 

.)

To display connection information for Distributed MAPs configured on a 
WX switch, use the following command:

display ap global [apnumber | serial-id serial-ID]

This command lists the System IP addresses of all the WX switches on 
which each Distributed MAP is configured, and lists the bias for the MAP 
on each switch. For each Distributed MAP that is configured on the 
switch on which you use the command, the connection number is also 
listed.

Connections are shown only for the Distributed MAPs that are configured 
on the WX from which you enter the command, and only for the Mobility 
Domain the WX is in.

To display connection information for all Distributed MAPs configured on 
a WX switch, type the following command:

WX4400# display ap global
Total number of entries: 8
AP  Serial Id   

WX IP Address Bias

--- ----------- 

--------------- ----

1 

M9DE48B012F00 10.3.8.111      HIGH

- 

M9DE48B012F00 10.4.3.2        LOW

2 

M9DE48B123400 10.3.8.111      LOW

- 

M9DE48B123400 10.4.3.2        HIGH

17  M9DE48B123600 10.3.8.111      HIGH
- 

M9DE48B123600 10.4.3.2        LOW

18  M9DE48B123700 10.3.8.111      LOW
- 

M9DE48B123700 10.4.3.2        HIGH