3com WXR100 3CRWXR10095A User Manual
630
C
HAPTER
A: T
ROUBLESHOOTING
A
WX S
WITCH
Mark messages are disabled by default. When they are enabled, MSS
generates a message at the notice level once every 300 seconds by
default.
generates a message at the notice level once every 300 seconds by
default.
To enable mark messages, use the following command:
WX4400# set log mark enable
success: change accepted.
success: change accepted.
Saving Trace Messages in a File
To save the accumulated trace data for enabled traces to a file in the WX
switch’s nonvolatile storage, use the following command:
switch’s nonvolatile storage, use the following command:
save trace filename
To save trace data into the file trace1 in the subdirectory traces, type the
following command:
following command:
WX1200# save trace traces/trace1
Displaying the Log Configuration
To display your current log configuration, type the following command:
WX1200# display log config
Logging console:
Logging console:
enabled
Logging console severity:
INFO
Logging sessions:
enabled
Logging sessions severity:
INFO
Logging buffer:
enabled
Logging buffer severity:
ERROR
Logging buffer size:
400 messages
Logging trace:
enabled
Logging trace severity:
DEBUG
Logging buffer size:
1048576 bytes
Log marking: disabled
Log marking severity: NOTICE
Log marking interval: 300 seconds
Logging server:
Log marking severity: NOTICE
Log marking interval: 300 seconds
Logging server:
172.21.12.19 port 514 severity
EMERGENCY
severity CRITICAL
Current session:
severity CRITICAL
Current session:
disabled
Current session severity:
INFO