3com WXR100 3CRWXR10095A User Manual

To display port group information, use the following command:

display port-group [name group-name]

To display the configuration and status of port group server2, type the 
following command:

WX1200# display port-group name server2
Port group: server2 is up

  Ports:  2, 5

Load-sharing port groups are interoperable with Cisco Systems 
EtherChannel capabilities. To configure a Cisco Catalyst

 

switch to 

interoperate with a 3Com WX switch, use the following command on the 
Catalyst switch:

set port channel port-list mode on

The CLI commands in this chapter configure VLANs on WX switch 
network ports. The commands do not configure VLAN membership for 
wireless or wired authentication users. To assign a user to a VLAN, 
configure the RADIUS Tunnel-Private-Group-ID attribute or the 
VLAN-Name vendor specific attribute (VSA) for that user. (For more 
information, see Chapter 21, “Configuring AAA for Network Users,” on 
page 433.)

A virtual LAN (VLAN) is a Layer 2 broadcast domain that can span multiple 
wired or wireless LAN segments. Each VLAN is a separate logical network 
and, if you configure IP interfaces on the VLANs, MSS treats each VLAN 
as a separate IP subnet. 

Only network ports can be preconfigured to be members of one or more 
VLAN(s). You configure VLANs on a WX switch’s network ports by 
configuring them on the switch itself. You configure a VLAN by assigning 
a name and network ports to the VLAN. Optionally, you can assign VLAN 
tag values on individual network ports. You can configure multiple VLANs 
on a WX switch’s network ports. Optionally, each VLAN can have an IP 
address.