3com wx3010 ac poe 8get 2sfp User Manual
3-23
Step4
Fasten the captive screws on the XFP module to secure it in place.
z
Keep the removed blank panel properly for future use.
z
Do not over-tighten the captive screws on the front panel of the interface module.
Removing an XFP interface module
Step1
Put on an ESD-preventive wrist strap and check that the wrist strap is properly grounded.
Step2
Use a Philips screwdriver to loosen the captive screws on the front panel of the XFP interface module.
Step3
Pull the XFP interface module toward you until it is completely out of the device chassis.
When installing or removing an optional interface module, pay attention to the following points:
z
Do not use excessive force in the operation and do not touch the surface-mounted components
directly with your hands.
directly with your hands.
z
After removing an optional module, if the slot is to remain empty, install a blank panel to prevent
dust and ensure normal ventilation in the device.
dust and ensure normal ventilation in the device.
XENPAK Module
Introduction
The 10-Gigabit Ethernet transceiver package (XENPAK) module provides the optical-to-electrical and
electrical-to-optical conversion function and multiple signal processing functions.
electrical-to-optical conversion function and multiple signal processing functions.
Front panel of an XENPAK module
Figure 3-34
Front view of an XENPAK module
Installing an XENPAK module
Step1
Put on an ESD-preventive wrist strap and verify that the wrist strap is properly grounded. Then, take the
XENPAK module out of the package.
XENPAK module out of the package.