audio-design la-1x12v User Manual
Model
LA-1X12V
LA-2X12V
Woofer Size
12”
12” (2)
Wired
Impedance
4
Ω
2
Ω
Power Handling
(MAX)
400 watts
800 watts
Power Handling
(RMS)
150 watts
300 watts
Width
19.8”
33.6”
Height (A)
15.6”
15.6”
Height (B)
14”
N/A
Depth (A)
13.5”
13.5”
Depth (B)
16”
16”
Enclosure Volume
1.6 ft
3
3.2 ft
3
Tuning Frequency
35 Hz
35 Hz
Installation
Preliminary Considerations:
• If you feel unsure about installing this system yourself, have it installed by a qualified technician.
• Think before you drill! Be careful not to cut or drill into gas tanks, fuel lines, brake or hydraulic lines, vacuum lines or electrical wiring when working on any
vehicle.
CAUTION: Before installation, disconnect the battery negative (-) terminal to prevent damage to the unit, fire and/or possible injury.
1. Run the speaker cable from the amp, avoiding running it close to any sources of high current (wiring harnesses).
2. The positive (+) speaker output from the amp connects to the red terminal of the enclosure, and the negative (-) connects to the black terminal.
NOTE: The woofer(s) is/are pre-wired internally to the impedance listed in the specification chart. Additional impedances can be obtained by re-wiring.
Preliminary Considerations:
• If you feel unsure about installing this system yourself, have it installed by a qualified technician.
• Think before you drill! Be careful not to cut or drill into gas tanks, fuel lines, brake or hydraulic lines, vacuum lines or electrical wiring when working on any
vehicle.
CAUTION: Before installation, disconnect the battery negative (-) terminal to prevent damage to the unit, fire and/or possible injury.
1. Run the speaker cable from the amp, avoiding running it close to any sources of high current (wiring harnesses).
2. The positive (+) speaker output from the amp connects to the red terminal of the enclosure, and the negative (-) connects to the black terminal.
NOTE: The woofer(s) is/are pre-wired internally to the impedance listed in the specification chart. Additional impedances can be obtained by re-wiring.