Autodesk autocad electrical 2005 Quick Setup Guide
10
|
Chapter 1 Wires
Trimming Wires
After you insert wires, you may need to trim them. The Trim Wire tool
removes wire segments. You can trim single or multiple wires.
removes wire segments. You can trim single or multiple wires.
To trim a wire
1
Click the Trim Wire tool.
Menu
Wires
➤ Trim Wire
2
Respond to the prompts as follows:
Fence/Zext/<Select wire to TRIM>:
Specify the wire segment at line reference 404 between the two vertical wires (1)
Specify the wire segment at line reference 404 between the two vertical wires (1)
Wire segments are trimmed back to a connecting dot, a component, or
completely if neither is encountered along the segment. Any connection
dots that are no longer needed are removed.
completely if neither is encountered along the segment. Any connection
dots that are no longer needed are removed.
The trimmed wire resembles the following image:
This is the end of this tutorial chapter.
1