ADC megabit modem 410f User Manual
Megabit Modem 410F and 420F User Manual
47
6
C
ONFIGURING THE
P
ORTS
Configure the connection between the Megabit Modem 410F and 420F using the
Brouter
LAN-WAN Configuration
page. You can configure both the Megabit Modem 410F and 420F as a
bridge to forward Ethernet data based on MAC addresses, as a router to route
Ethernet-encapsulated IP datagrams based on IP addresses, or as both. If you select both, the
modem routes all IP datagrams and bridges everything else. Be sure to configure the same
settings for both modems. For more information about these options, see
Ethernet-encapsulated IP datagrams based on IP addresses, or as both. If you select both, the
modem routes all IP datagrams and bridges everything else. Be sure to configure the same
settings for both modems. For more information about these options, see
.
Configure the ADSL connection between the Megabit Modem 410F and 420F using the
CO End
ADSL (DMT) Configuration
page from the 410F (ATU-C). For more information about the ADSL
connection, see
and
Do the following to configure the Megabit Modem 410F and 420F:
•
Configure parameters for communicating between the Megabit Modem 410F and 420F
over the WAN, and set up the LAN side of the configuration, including DHCP. If DHCP is
enabled, the modem will serve IP addresses to devices on the LAN (
over the WAN, and set up the LAN side of the configuration, including DHCP. If DHCP is
enabled, the modem will serve IP addresses to devices on the LAN (
) when routing
is enabled.
•
Configure ADSL service between the Megabit Modem 410F and 420F (
).
•
Save the configuration and effect your changes (
Although you have submitted your configuration changes:
•
some LAN-WAN parameter changes are not permanent until you write them
to NVRAM and do not take effect until you reset the modem
to NVRAM and do not take effect until you reset the modem
•
ADSL parameter changes do not take effect until you reset the ADSL link
See
for
additional information.