Avaya 4600 User Manual
4600 Series IP Telephone Installation Guide
Pre-Installation Checklist for Static Addressing
3-2
3.
If a numeric digit is entered for a value or for a field of an IP address or subnet mask after only
a zero has been entered, the new digit will replace the zero.
a zero has been entered, the new digit will replace the zero.
4.
Press the # button to go to the next step.
5.
To backspace within a field, press the leftmost button under the display (the leftmost softkey
on a 4624 or 4612 or the conference button on a 4606) or the previous button (on the 4624
and 4612): the most recently entered digit or period is erased from the display, and the cursor
is left in the erased character’s former position.
on a 4624 or 4612 or the conference button on a 4606) or the previous button (on the 4624
and 4612): the most recently entered digit or period is erased from the display, and the cursor
is left in the erased character’s former position.
Pre-Installation Checklist for Static Addressing
3
Before performing static addressing on the 4600 Series IP Telephone, verify that all of the
requirements listed on page 2-2 have been met (other than item 4 referring to the DHCP server).
In addition, you must have the values for the following parameters. Failure to do so may cause
errors during data entry, which will prevent the telephone from working and may have a negative
impact on your network. Print copies of this checklist for each subnet.
requirements listed on page 2-2 have been met (other than item 4 referring to the DHCP server).
In addition, you must have the values for the following parameters. Failure to do so may cause
errors during data entry, which will prevent the telephone from working and may have a negative
impact on your network. Print copies of this checklist for each subnet.
Static Addressing Installation
3
The usual way to assign IP addresses to IP Telephones is the automatic method described in
‘‘Dynamic Addressing Process’’ on page 2-6. There may be times, however, when manual
assignment of IP addresses is desired
‘‘Dynamic Addressing Process’’ on page 2-6. There may be times, however, when manual
assignment of IP addresses is desired
WARNING:
Static addressing is necessary when a DHCP server is unavailable.
Due to the difficulties associated with static addressing, it is very strongly recommended that
a DHCP server be installed and that static addressing be avoided.
a DHCP server be installed and that static addressing be avoided.
!
1.
The IP Address of the call server/gatekeeper
!
2.
The transport layer port number of the Address of the Management Complex (call
server/gatekeeper). Although this may be a value between 0 and 65535, the default
value is 1719 and should not be changed unless this conflicts with an existing port
assignment.
server/gatekeeper). Although this may be a value between 0 and 65535, the default
value is 1719 and should not be changed unless this conflicts with an existing port
assignment.
!
3.
The IP Address of the gateway/router
!
4.
The IP netmask
!
5.
The IP Address of the TFTP server