Avaya 1010 User Manual

Avaya 1010/1020 User Guide

43

If this reset fails or if you do not have access to the user interface, you can manually reset 
the system using the Reset button on the back of the codec without removing power to the 
system. 

Press and hold the reset button. The blue LED on the front of the codec changes color or 
behavior approximately every five seconds until the LED turns solid blue. The following table 
indicates the sequence of color and behavior changes that the LED exhibits and the 
corresponding effect on the system when you release the reset button.

blue and red 

Note: The LED may remain in this 
state for more than 5 seconds. 
Depending on your viewing angle, 
the LED may appear purple.

The system reboots without changes to the configuration. 

solid red

The system reboots without changes to the configuration.

flashing blue (longer duration on than 
off)

The system reboots and resets preferences to their default settings.

flashing blue (shorter duration on 
than off)

The system reboots at the initial configuration using the alternate 
software image installed on the system and resets values to default 
settings.

solid blue

If you release the reset button when the LED turns solid blue the 
system stops and does not reboot. Continue to hold the reset button 
until the system reboots (approximately 5 to 10 seconds after the LED 
turns solid blue). The system reboots without changes to the 
configuration.