Avaya P332G-ML User Manual
Chapter 3
8
Avaya P332G-ML User’s Guide
Safety
•
UL for US approved according to UL195O Std.
•
C-UL(UL for Canada) approved according to C22.2 No.950 Std.
•
CE for Europe approved according to EN 60950 Std.
•
Laser components are Laser Class I approved:
— EN-60825/IEC-825 for Europe
— FDA CFR 1040 for USA
— EN-60825/IEC-825 for Europe
— FDA CFR 1040 for USA
Safety - AC Version
•
Overcurrent Protection: A readily accessible Listed safety-approved protective
device with a 16A rating must be incorporated in series with building
installation AC power wiring for the equipment under protection.
device with a 16A rating must be incorporated in series with building
installation AC power wiring for the equipment under protection.
Safety - DC Version
•
Restricted Access Area: This unit must be installed in Restricted Access Areas
only.
only.
•
Installation Codes: This unit must be installed in accordance with the US
National Electrical Code, Article 110, and the Canadian Electrical Code,
Section 12.
National Electrical Code, Article 110, and the Canadian Electrical Code,
Section 12.
•
Conductor Ampacity: Per UL 1950, Annex NAE (NEC Article 645-5(a)), the
branch-circuit conductors supply shall have the ampacity of not less than 125
percent of the total connected load. For input leads use at least 18 AWG copper
conductors.
branch-circuit conductors supply shall have the ampacity of not less than 125
percent of the total connected load. For input leads use at least 18 AWG copper
conductors.
•
Overcurrent Protection: Per UL 1950, Annex NAE (NEC Article 240-3), a readily
accessible listed branch-circuit overcurrent protective device rated maximum
10A must be incorporated into the building wiring.
accessible listed branch-circuit overcurrent protective device rated maximum
10A must be incorporated into the building wiring.
EMC Emissions
Emissions
Approved according to:
•
•
US - FCC Part 15 sub part B, class A
•
Europe - EN55022 class A and EN61000-3-2
•
Japan - VCCI-A
Immunity
Approved according to:
•
•
EN 55024 and EN61000-3-3