HP designjet l65500 Manual
The substrate sticks to the platen
When the substrate sticks to the platen, the most likely causes are excessive heat and excessive
vacuum. Therefore, try decreasing the drying temperature or the vacuum.
vacuum. Therefore, try decreasing the drying temperature or the vacuum.
For information on how to adjust printer settings, see the User's guide.
The ink is still wet when the substrate emerges
1.
Reduce the ink limits.
2.
Increase temperature settings for drying and curing.
For information on how to adjust printer settings, see the User's guide.
There are ink marks on the substrate
This problem can be caused by the carriage touching the substrate and smearing the ink.
1.
If the ink marks occur at the sides of the substrate and not in the center, check that the substrate
edge holders are correctly placed.
edge holders are correctly placed.
2.
Check that the vacuum and tension levels are correct.
3.
If you see large drops of ink, clean the printheads to remove any loose fibers.
For information on how to adjust printer settings, see the User's guide.
ENWW
The substrate sticks to the platen
33
Subst
rat
e i
ssue
s