HP enterprise 9000 User Manual
2- 5
R Class System Installation
1. Install the Rack Kit and Server Into the Cabinet
6. Make sure the sheet metal nuts are aligned with the mounting holes in the rail.
7. Insert the M5x30mm mounting screws through the mounting holes on each rail,
(through the spacers, if used), into the sheet metal nuts, and tighten. See the figures
below for an example. The figure on the left shows installation without spacers.
(through the spacers, if used), into the sheet metal nuts, and tighten. See the figures
below for an example. The figure on the left shows installation without spacers.
8. Install the new piece of computer equipment. Slide it all the way into the cabinet.
9. Slip the clamp into the rails from the rear of the cabinet or rack (one for each rail).
The raised edge of the clip should cover the rear edge of the computer equipment.
The raised edge of the clip should cover the rear edge of the computer equipment.