HP laserjet 3390, 3392 all-in-one Service Manual
![HP](https://files.manualsbrain.com/attachments/29005dca542c93ad59e01e223583dbd51961550d/common/fit/150/50/3931a36faa9f1af0627fe52b73d277ccf98e5d18c55433f253353db13ee5/brand_logo.jpeg)
Laser/scanner
CAUTION
PCAs are sensitive to electrostatic discharge (ESD). Look for the ESD
reminder when removing PCAs. Always perform service work at an ESD-protected workstation
or mat. If an ESD workstation or mat is not available, ground yourself by touching the sheet-metal
chassis before touching an ESD-sensitive part.
or mat. If an ESD workstation or mat is not available, ground yourself by touching the sheet-metal
chassis before touching an ESD-sensitive part.
Protect the ESD-sensitive parts by placing them in ESD pouches when they are out of the all-in-
one.
one.
CAUTION
Do not bend or fold the flat flexible cables (FFCs) during removal or installation. Also,
do not straighten pre-folds in the FFCs. You must make sure that all FFCs are fully seated in their
connectors. Failure to fully seat an FFC into a connector can cause a short circuit in a PCA.
connectors. Failure to fully seat an FFC into a connector can cause a short circuit in a PCA.
1.
Remove the following components.
●
Right cover. See
●
Left cover. See
.
●
Rear cover. See
.
●
Top cover. See
.
2.
Disconnect one FFC (callout 1) from the laser/scanner PCA.
3.
Disconnect one connector (callout 2) from the top of the laser/scanner.
4.
Remove all of the wire-harnesses (callout 3) from the retainers.
NOTE
Examine the cable routing as you remove the wire-harnesses.
148
Chapter 5 Removal and replacement
ENWW