HP laserjet 1018 Service Manual
8.
Disconnect one flat flexible (ribbon) cable and the connector to the step motor (callout 4).
Remove two screws (callout 5). Loosen the tape (callout 6) that secures the cable to the
chassis. As you remove the ECU, unplug the additional connector to the laser/scanner assembly.
Remove two screws (callout 5). Loosen the tape (callout 6) that secures the cable to the
chassis. As you remove the ECU, unplug the additional connector to the laser/scanner assembly.
CAUTION
Do not pull directly on the wires when a connector is disconnected. Always
pull on the plastic body of a connector to avoid damaging the connector wires.
5
6
4
Figure 5-33
Remove the ECU assembly (6 of 6)
Reinstallation tip
When reinstalling the ECU metal casing, make sure that the laser/
scanner shutter lever is inserted correctly through the plastic guide.
ENWW
Internal assemblies
83