HP omnibook 4000 Service Manual

___________

25

Lift the display straight up about 1 inch.  The Icon Assembly will lift up with the
display.  Move the Icon assembly out of the way.  The cable from the Icon
Assembly to the PC board does not need to be removed if only the display is being
removed.  Otherwise, slide the connector sleeve foward to remove the Icon
Assembly cable.

Next, remove the two cables attaching the display module to the PC board.  Lastly,
remove the two screws attaching the grounding straps to the PC board.  The
display can now be removed the rest of the way.

Display/Chassis
Screws

To reinstall the display module or Icon Assembly, just reverse the above
procedure.  When reinstalling the Display Module, make sure that the two posts on
either side of the display line up parallel with their slots in the top case.  If they are
not parallel, the post will get caught inside the top case before the display is seated
completely.  If this happens, remove the display and line the posts up properly.
Also take care that the Icon Assembly flex cable is tucked inside of the “tunnel” of
the Icon Assembly.  This will prevent the cable from crimping and possibly
malfunctioning.