HP pavilion tx2000 Service Manual

12.1-inch, WXGA, BrightView touch-screen display assembly with Web camera, fingerprint reader,

microphones, and WLAN antenna cables

464144-001

12.1-inch, WXGA, BrightView touch-screen display assembly with Web camera, microphones, and

WLAN antenna cables

464142-001

12.1-inch, WXGA, BrightView touch-screen display assembly with fingerprint reader, microphones and

WLAN antenna cables

464145-001

12.1-inch, WXGA, BrightView touch-screen display assembly with microphones and WLAN antenna

cables

464143-001

Before removing the display assembly, follow these steps:

Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the

computer on, and then shut it down through the operating system.

Disconnect all external devices connected to the computer.

Disconnect the power cord.

Remove the battery (see 

Remove the memory module compartment cover (see 

Remove the WLAN module compartment cover and disconnect the wireless antenna cables from the

WLAN module (see 

).

Remove the switch cover (see 

).

Remove the display assembly:

Close the computer and turn it upside down, with the front toward you.

Loosen the Phillips PM2.0×5.0 captive screw (1) that secures the display connector cover to the

computer.

Lift the rear edge of the display connector cover (2) and swing it toward you.

Remove the display connector cover.

The display connector cover is included in the Plastics Kit, spare part number 464114-001.

Component replacement procedures 51