GE profile upgt650 User Manual

Page of 72
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT
– Save these instructions for
local electrical inspector’s use.
IMPORTANT
– Observe all governing codes
and ordinances.
• Note to Installer – Be sure to leave these
instructions with the Consumer.
• Note to Consumer – Keep these instructions for
future reference.
• This dryer must be exhausted to the outdoors. 
• Before the old dryer is removed from service or
discarded, remove the dryer door.
• Service information and the wiring diagram are
located in the control console.
• Do not allow children on or in the appliance. Close
supervision of children is necessary when the
appliance is used near children.
• Proper installation is the responsibility of 
the installer. 
• Product failure due to improper installation 
is not covered under the Warranty
.
• Gas dryers are not approved for mobile home
installation.
Installation 
Dryer 
Instructions
DPGT650 and UPGT650
14
Questions? Call 800.GE.CARES (800.432.2737) or visit our Web site at: ge.com
In Canada, call 1.800.561.3344, or visit geappliances.ca
FOR YOUR SAFETY:
WARNING
• Use only rigid metal or flexible metal 4-inch
diameter ductwork for exhausting to the
outdoors. Never use plastic or other combustible
easy-to-puncture ductwork.
• This appliance must be properly grounded and
installed as described in these instructions.
• Do not install or store appliance in an area where
it will be exposed to water and/or weather.
• The National Fuel Gas Code restricts installations
of gas appliances in garages. They must be 18
inches off the ground and protected by a barrier
from vehicles.
• Install the dryer where the temperature is above
50°F for satisfactory operation of the dryer
control system.
FOR GAS MODELS ONLY:
NOTE: Installation and service of this dryer must
be performed by a qualified installer, service
agency or the gas supplier.
In the Commonwealth of Massachusetts: 
• This product must be installed by 
a licensed plumber or gas fitter.
• When using ball-type gas shut-off valves, 
they shall be T-handle-type.
• A flexible gas connector, when used, 
must not exceed 3 feet.