HP proliant dl580 User Manual
Removal and replacement procedures 39
IMPORTANT: Be sure to set the SCSI simplex/duplex switch to the appropriate setting when replacing the
SCSI backplane.
To replace the component, reverse the removal procedure.
Removing the power backplane
1.
Power down the server (on page
2.
Remove all power supplies ("
NOTE: If you remove or replace the primary hot-plug power supply, use the T-15 Torx screwdriver provided
with the server to remove the shipping screw. It is located just under the port-colored plastic handle of the
power supply unit.
power supply unit.
3.
Extend or remove the server from the rack ("
4.
Remove the access panel ("
5.
Remove the system cage ("
6.
Loosen the thumbscrew, and remove the power backplane from the server.
To replace the component, reverse the removal procedure.
Removing the memory backplane
1.
Power down the server (on page
2.
3.
Remove the processor module ("
4.
Extend or remove the server from the rack ("
5.
Remove the access panel ("