HP ProLiant ML330 G6 User Manual
Hardware options installation 70
o
Extend the server from the rack (on page
3.
Remove the access panel (on page
4.
Remove the expansion slot cover ("
5.
Install the SAS controller ("
6.
Disconnect the SATA cable from the hard drive backplane and from the system board.
7.
Connect the SAS cable to the hard drive backplane and to the SAS controller.
8.
).
9.
Do one of the following:
o
Close or install the tower bezel, as needed.
o
Slide the server back into the rack.
10.
Power up the server (on page
Dedicated iLO 2 port module option
To install the component:
1.
Power down the server (on page
2.
Do one of the following:
o
Open or remove the tower bezel, as needed ("
o
Extend the server from the rack (on page
3.
Remove the access panel (on page
4.
Using a Phillips screwdriver, remove the dedicated iLO 2 connector module blank.