Canon imageclass 2300 Information Guide
Replacing the Toner Cartridge
9-2
Replacing the Toner Cartridge
When the machine runs out of toner, the alarm lamp blinks and the message
<REPLACE CARTRIDGE> appears on the display. When this happens, remove the
toner cartridge from the machine and slowly shake it sideways to redistribute toner.
Reinstall the toner cartridge in the machine and print out a test page. If the error
message still appears, replace the toner cartridge.
<REPLACE CARTRIDGE> appears on the display. When this happens, remove the
toner cartridge from the machine and slowly shake it sideways to redistribute toner.
Reinstall the toner cartridge in the machine and print out a test page. If the error
message still appears, replace the toner cartridge.
WARNING
Do not burn or throw used toner cartridges into open flames, as they may cause
the toner remaining inside the cartridges to ignite, resulting in burns or a fire.
the toner remaining inside the cartridges to ignite, resulting in burns or a fire.
IMPORTANT
Use only the toner cartridge recommended for use with this machine.
Replace the toner cartridge after the message <REPLACE CARTRIDGE> is displayed.
Do not expose the toner cartridge to direct sunlight or strong light.
Do not leave the left cover open for a long time after the toner cartridge is installed.
Replace the toner cartridge after the message <REPLACE CARTRIDGE> is displayed.
Do not expose the toner cartridge to direct sunlight or strong light.
Do not leave the left cover open for a long time after the toner cartridge is installed.
NOTE
After the message <REPLACE CARTRIDGE> appears, approximately 150 prints can still
be made. However, since this number may vary depending upon the original, it is
recommended to replace the toner cartridge soon after the <REPLACE CARTRIDGE>
message appears.
If the toner runs out during a print job, the machine will start printing the remaining pages
automatically after you replace the toner cartridge.
A copy/print job will not stop until it is completed, but some fading might occur on the
printout as the toner cartridge becomes empty. If you set <TONER SUPPLY LOW> to '01
RX TO MEMORY', the fax job stops. If you set it to '02 KEEP PRINTING', the fax job
continues, but the printout will be faint or illegible.
be made. However, since this number may vary depending upon the original, it is
recommended to replace the toner cartridge soon after the <REPLACE CARTRIDGE>
message appears.
If the toner runs out during a print job, the machine will start printing the remaining pages
automatically after you replace the toner cartridge.
A copy/print job will not stop until it is completed, but some fading might occur on the
printout as the toner cartridge becomes empty. If you set <TONER SUPPLY LOW> to '01
RX TO MEMORY', the fax job stops. If you set it to '02 KEEP PRINTING', the fax job
continues, but the printout will be faint or illegible.
Maintenance
9