Nikon COOLPIX 4500 Maintenance Manual
VAA11901-R.3579.A
- A2・E4500 -
Lens unit
Finder unit
Spacer
Spacer(Brown)
①
Spacer
Finder coupling pin
• Attach the 3 pieces of spacers shown in Picture on the
left to the lens unit.
• Set the finder coupling pin and the claw of lack plate
on the finder unit. Then attach the finder unit with the 3
screws
left to the lens unit.
• Set the finder coupling pin and the claw of lack plate
on the finder unit. Then attach the finder unit with the 3
screws
①
(1.4 x 3.5).
• Apply a piece of tape (brown) and spacer to the bottom
of the lens unit.
of the lens unit.
[Position where the tape and spacer should be applied.]
Rack plate
• Move the finder lens to the right end.
• Set the horizontal line on the cam to the center of
the cam shaft.
• Assemble the rack plate by sliding it in a direction
pointed by an arrow.
• After assembling them, be sure to check the position
as mentioned in Page A1.
• Set the horizontal line on the cam to the center of
the cam shaft.
• Assemble the rack plate by sliding it in a direction
pointed by an arrow.
• After assembling them, be sure to check the position
as mentioned in Page A1.
Cam
Finder lens
(Note) If the rack plate is removed or the cam is
not in the right position, assemble the rack plate by
following way.
not in the right position, assemble the rack plate by
following way.
3. Lens unit
Spacer(Brown)
Spacer