Samsung sv-dvd54t User Manual
ENG-19
Using the G-CODE Feature
◆
The programme number or times flash
◆
You wish to modify the programme
4
If the programme and times are correct, press the
RETURN button.
RETURN button.
5
Press the STANDBY/ON button to activate the
timer.
timer.
6
Refer to page 21~22 if you wish to:
◆
Check that your STB-DVD-VCR has been
programmed correctly
◆
Cancel a preset recording
☛
The numbers next to each TV programme listing
are G-Code code numbers, which allow you to
programme your STB-DVD-VCR instantly with
the remote control. Tap in the G-Code code for
the programme you wish to record.
are G-Code code numbers, which allow you to
programme your STB-DVD-VCR instantly with
the remote control. Tap in the G-Code code for
the programme you wish to record.
™G-Code is a trademark of Gemstar Development
Corporation. The G-Code system is manufactured under
licence from Gemstar Development Corporation.
licence from Gemstar Development Corporation.
3
Press the OK button.
Result: The information concerning the programme
Result: The information concerning the programme
is displayed.
☛
When using the G-Code function for the
first time with stored stations, the programme
number flashes. This one time, you must enter
the station number manually by pressing the
first time with stored stations, the programme
number flashes. This one time, you must enter
the station number manually by pressing the
or
❷
buttons. Refer to the following page if:
Before presetting your STB-DVD-VCR:
◆
Switch on both the television and your STB-DVD-
VCR
VCR
◆
Check that the date and time are correct
◆
Insert the cassette on which the programme is to
be recorded (safety tab intact)
Up to six programmes can be preset.
1
To enter a G-Code, press the TIMER button.
Press the
Press the
or
❷
and OK or
❿
buttons to select
G-Code
Result: A message is displayed to allow you to
Result: A message is displayed to allow you to
enter the G-Code code.
☛
If all six programmes have been set, the
message Timer is full is displayed. Refer to
page 22 if you wish to cancel a preset recording.
message Timer is full is displayed. Refer to
page 22 if you wish to cancel a preset recording.
2
Press the numeric buttons to enter the code
opposite the programme that you wish to record in
your television magazine.
opposite the programme that you wish to record in
your television magazine.
➢
If you wish to correct the G-Code code that
you are entering:
you are entering:
◆
Press the
➛
button until the digit to be
corrected is cleared
◆
Enter the correct digit
Standard
G-Code
Timer Method
G-Code
Code
Code : 0 - 9
Correct :