Samsung sw62asp User Manual

5

1.   Push the upper part of 

the filter and pull in.

2.  Open the cover as 

shown in the figure.

3. Clean the filter.

4.  Close the cover and insert the lower 

part of the filter in  the basket first and 

then push the filter with "click" sound .



  When a proper amount (one time does) of 

fabric softener is stored in the softener inlet,it is 
automatically put in at the last rinsing cycle.



  Do not use detergent, bleach or starch into the 

Softener Inlet.



  Using too much softener may produce 

unsatisfactory results.



  Do not open the lid during the Spin Dry cycle. 

If added too early, its effectiveness will decrease.



  Do not leave the softener  

into the Softener  
Dispenser for a long time.  
Because softner  
became stiff.

1.  Open the detergent box by pulling in the direction of the arrow as shown in the figure and then put the 

powder detergent in the detergent box.

2.  Put in one-time amount of detergent  evenly so the detergent  may not brim over the box.

Caution : If softener is stored over the above base line, it may flow down at any time.

1. Place a rag under washer filter not to wet the floor.
2. Turn the filter-cap to the left.
3. Take out the filter and remove any sludge.
4. Reassemble in reverse order.

•  If the washer is not leveled with the ground, it makes the 

machine tremble more or be out of order. So, make sure 
that the washer is leveled properly.



  Open the lid of the machine, pour water into the tub up 

to the level just below the pulsator, and adjust the legs so 
that the pulsator is positioned at the center of the water 
as shown in the figure.



  Place the machine more  than  

10cm away from the wall.



  Adjust the legs on feet  

for levelling .



  

Put the detergent in proportion to water level

 Loosen               Lock

Water

SW62ASP-01488K_EN.indd   5

2006-06-05   ｿﾀﾀ・9:15:09