Samsung wa10k2q User Manual

1.Pull out the filter and wash well.

2. Pull in the filter and connect

the hose to the inlet water 
valve tightly.

inlet water 
valve

3. Check if there is a leakage.

Note to tighten up the 

connector.

Clean the filter net often to keep the washer clean.

1. Push the upper part

of the filter and pull in.

2. Open the cover as 

shown in the figure.

3. Clean the filter.

4. Close the cover and insert the 

lower part of the filter in the 
basket first and then push the 
filter with "click" sound .

1. Place a rag under the washer filter not to wet the floor.
2. Rotate the filter counterclockwise 

and pull out the filter. 

3. Remove dirts and rotate 

the filter clockwise 
until it locks in position.

(pump drained washer)
1.Place a rag under washer filter not to wet the floor.
2.Turn the filter-cap to the left.
3.Take the filter out and 

remove dirts.

4. Reassemble in 

reverse order.

1. Push up and 

pull out the filter net.

2. Remove the collected

lint from the filter net.

3. Clean the filter.

4.  Pull down the filter net.

1. Check the 4 Legs.(Front-right. Front-left. 

Rear-right. Rear-left)

2. Lay down the Washing Machine to the front.
3. Insert the hook of leg in to the square hole 

of base.

4. Push the leg to the arrow direction to “Click”.
5. Finaly fix the legs on the base

with screw like a figure.

1

2

Base

Hole

Hook

Screw

KS6-01216A-noninverter  11/12/02 6:37 PM  Page 10