Sony 3-873-945-12 (1) User Manual

27

Using the wireless remote control function

Press the + or – button repeatedly until 
the RF REMOTE indication is 
displayed.

Hold down the SET button until the 
item to be set flashes.

Press the + or – button repeatedly to 
select PAIRING.

Press the SET button to enter.

The transmitter sends a pairing request 
to the receiver which is on pairing 
mode.
Before established pairing, if you press 
any operation key on the transmitter, 
pairing mode will be cancelled.
When pairing has been established, the 
wireless remote control condition level 
(indicated by 

) goes up, RF 

REMOTE turns on, and the remote 
control function becomes operative.

In the RF REMOTE indication, select ON.

 

• When you set RF REMOTE to ON, the 

transmitter will communicate with the 
receiver to which it was previously 
paired. To use the wireless remote 
control function with another receiver, 
you must perform the pairing procedure 
for that receiver.

• Multiple transmitters cannot be paired 

with the same receiver. 

The following transmitter settings 
can be done from the wireless 
remote control:
• Group/channel/BAND setting

• RF transmission power setting
• Attenuator for the audio input setting
• Low-cut filter setting
• Power save setting

In the RF REMOTE indication, select OFF.

The wireless remote control function on the 
transmitter uses the 2.4-GHz band and may 
thus be subject to interference from other 
devices.
• When pairing fails (“Pairing fail” is 

displayed), successful communication 
between the transmitter and the receiver 
has not occurred within a given amount 
of time. Pairing may be harder to do 
when another receiver is engaged in 
pairing nearby. 

• When it becomes hard to use the remote 

control, the remote control may be 
improved by switching the wireless 
remote control function off, then on again 
in the RF REMOTE display, then re-
pairing with the transmitter (change to a 
channel with less interference).