Sony 3-299-549-12(1) User Manual

D.C.A.C. (Digital Cinema Auto Calibration) can 
set the appropriate surround sound 
automatically.

• The system outputs a loud test sound when [AUTO 

CALIBRATION] starts. You cannot turn the volume 
down. Give consideration to children and neighbours.

• Make sure that the headphones are not connected to 

the surround amplifier. You cannot operate the 
following steps with the headphones connected.

• Before [AUTO CALIBRATION], be sure that the 

surround amplifier turns on and you install the 
surround amplifier in the appropriate location. If you 
install the surround amplifier in an improper location, 
such as another room, proper measurement will not 
be obtained.

in stop mode.
The Control Menu display appears on the 
TV screen.

X/x to select 

The options for [SETUP] appear.

X/x to select [CUSTOM], then 

press .
The Setup Display appears.

X/x to select [AUDIO SETUP], 

The options for [AUDIO SETUP] appear.

X/x to select [AUTO 

The options for [AUTO CALIBRATION] 
appear.

Connect the calibration microphone 
(supplied) to the ECM-AC2 jack on the 
rear of the control unit.
Set up the calibration microphone at the ear 
level using the tripod, etc. (not supplied).
The front of each speaker should face the 
calibration microphone, and there should be 
no obstruction between the speakers and the 
calibration microphone. 

• The ECM-AC2 jack is used for the supplied 

calibration microphone only. Do not connect 
other microphones.

C/c to select [YES].

Press .
[AUTO CALIBRATION] starts.
Be quiet during the measurement.

DMPORT

Calibration microphone

Rear of the control unit

To ECM-AC2 jack