Sony 42lx1e User Manual

14

 (GB)

Before you start
• First make sure that the power to each piece of

equipment is turned off.

• Use connecting cables suitable for the equipment to

be connected.

• The cable connectors should be fully inserted into

the jacks. A loose connection may cause hum and
other noise.

• To disconnect the cable, pull it out by grasping the

plug. Never pull the cable itself.

• Refer to the instruction manual of the equipment to

be connected.

• Insert the plug securely into the AC IN socket.
• Use one of the two AC plug holders (supplied) that

will securely hold the AC plug.

You can enjoy viewing with a greater sense of
presence by connecting speakers SS-SP42FW/32FW
(not supplied). Please be sure to connect the speakers
correctly. For more details on connecting the
speakers, see the operating manual that came with the
speakers.

Plug the AC power cord into the AC IN socket.
Then, attach the AC plug holder (supplied) to the
AC power cord.

Slide the AC plug holder over the cord until it
connects to the AC IN socket cover.

AC IN socket
cover

Connections

To remove the AC power cord
After squeezing the AC plug holder and freeing it,
grasp the plug and pull out the AC power cord.

Attach the ferrite cores to the ends of the cable,
closing it until it clicks.

Wind the stopper around the cable so that the
ferrite core does not slide.

Tighten the stopper and cut the surplus.

• When you connect a cable to any of the terminals

listed below, attach the ferrite cores provided before
using the cable.
DVI-HDCP(INPUT1): Attach the ferrite cores to
both ends of the cable as shown in the illustrations.

• You are cautioned that this unit will not be in

compliance with the EMC limits unless you attach
the ferrite cores on the interconnecting cable.

AC plug holder

AC IN socket

AC power cord

Within 10 mm (

13

/

32

 inch)

Within 10 mm (

13

/

32

 inch)

Within 10 mm (

13

/

32

 inch)

Within 10 mm (

13

/

32

 inch)