Sony 60nx801 User Manual

Page of 24
6
Setting up your TV
Some TV models are packaged with a detached 
Table-Top Stand so you can mount your TV to 
a wall right away. If you are not mounting the 
TV to a wall, you will need to attach the Table-
Top Stand. You will need a Phillips 
screwdriver and the supplied screws to 
complete the task. Look for the attachment 
instructions provided with the TV. 
Be sure to consider the following while setting 
up your TV: 
Disconnect all cables when carrying the 
TV. 
Carry the TV with the adequate number of 
people; larger size TVs require two or more 
people. 
Correct hand placement while carrying the 
TV is very important for safety and to avoid 
damage. 
Ensure your TV has adequate ventilation, 
see page 16.
For best picture quality, do not expose the 
screen to direct illumination or sunlight. 
Avoid installing the TV in a room with 
reflective wall and floor materials. 
If the TV is brought directly from a cold to 
a warm location, or is placed in a very damp 
room, or is placed in a room in which 
heating has just been turned on, moisture 
may condense on the surface or inside the 
TV. Should this occur, turn off the TV and 
leave the TV off until the moisture 
evaporates, and then the TV can be used. If 
you notice moisture condensation between 
the glass panel and the LCD, turn on the TV 
and the condensation will evaporate after 
the TV has warmed up.
Attaching the Table-Top 
Stand
Refer to the supplied Table-Top Stand 
instruction leaflet for proper attachment for 
some TV models.
~
• Do not put stress on the LCD panel or the frame 
around the screen.
• Be careful to not pinch your hands or the AC 
power cord when you install the TV unit to the 
Table-Top Stand.
For KDL-52/46NX800 and KDL-46/
40NX700
1
Gently slide the TV unit onto the 
Table-Top Stand and align the screw 
holes.
2
Use the supplied screws to attach the 
TV unit to the Table-Top Stand. 
~
• If you use an electric screwdriver, set the 
tightening torque at approximately 1.5 N·m 
{15 kgf·cm}.
3
After all the screws are tighten cover 
the Table-Top Stand with the supplied 
Stand Rear Cover.