Sony a (alpha) slt-a33 User Manual

187

he
rs

The lens gets fogged.

• Moisture condensation has occurred. Turn off the camera and leave it for

about an hour before using it (page 192).

The message “Set Area/Date/Time.” appears when you turn on the
camera.

• The camera has been left unused for sometime with a low battery or no

battery pack. Charge the battery pack and set the date again (pages 28, 192).
If the date setting is lost every time the battery pack is charged, consult your
Sony dealer or local authorized Sony service facility.

The number of recordable images does not decrease or decreases two at
a time.

• This is because the compression rate and the image size after compression

change depending on the image when you shoot a JPEG image (page 143).

The setting is reset without the resetting operation.

• The battery pack was removed when the power switch was set to ON. When

removing the battery pack, make sure the camera is turned off and the
access lamp is not lit (pages 15 , 20).

The camera does not work properly.

• Turn off the camera. Remove the battery pack and insert it again. If the

camera is hot, remove the battery pack, and allow it to cool down before
trying this corrective procedure.

• If an AC Adaptor (sold separately) is used, disconnect the power plug.

Connect the power plug and turn on the camera again. If the camera does
not work after doing these solutions, consult your Sony dealer or local
authorized Sony service facility.

The five bars of the SteadyShot scale flashes.

• The SteadyShot function does not work. You can continue to shoot but the

SteadyShot function will not work. Turn the camera off and on. If the
SteadyShot scale continues to flash, consult your Sony dealer or local
authorized Sony service facility.

Others