Sony bluetooth bt3700u User Manual

Page of 180
7
E:\#Data Disc\1006_Saishin\4125655411\412565541MEXBT3700U\01GB02CD-
EUR.fm
masterpage:Right
MEX-BT3700U
4-125-655-41 (1)
Canceling the DEMO mode
You can cancel the demonstration display which 
appears during turning off.
1
Press and hold the select button.
The setup display appears.
2
Press the select button repeatedly 
until “DEMO” appears.
3
Rotate the control dial to select 
“DEMO-OFF.”
4
Press and hold the select button.
The setup is complete and the display returns 
to normal play/reception mode.
Preparing the card remote 
commander
Remove the insulation film.
Tip
For how to replace the battery, see page 26
.
Setting the clock
The clock uses a 24-hour digital indication.
1
Press and hold the select button.
The setup display appears.
2
Press the select button repeatedly 
until “CLOCK-ADJ” appears.
3
Press (SEEK) +.
The hour indication flashes.
4
Rotate the control dial to set the hour 
and minute.
To move the digital indication, press (SEEK) 
+/–.
5
After setting the minute, press the 
select button.
The setup is complete and the clock starts.
To display the clock, press (DSPL). Press 
(DSPL) again to return to the previous display.
Tip
You can set the clock automatically with the RDS 
feature (page 14)
.
Detaching the front panel
You can detach the front panel of this unit to 
prevent theft.
Caution alarm
If you turn the ignition switch to the OFF 
position without detaching the front panel, the 
caution alarm will sound for a few seconds.
The alarm will only sound if the built-in 
amplifier is used.
1
Press (OFF).
The unit is turned off.
2
Press 
, then pull it off towards you.
Notes
• Do not drop or put excessive pressure on the front 
panel and display window.
• Do not subject the front panel to heat/high 
temperature or moisture. Avoid leaving it in a parked 
car or on a dashboard/rear tray.
• Do not detach the front panel during playback of the 
USB device, otherwise USB data may be damaged.
Attaching the front panel
Engage part A of the front panel with part B of 
the unit, as illustrated, and push the left side into 
position until it clicks.
Note
Do not put anything on the inner surface of the front 
panel.
B
A