Sony bravia kdl-32ll150 User Manual

Many of the poor pictures and poor sound conditions are related to improper connection of the cables; refer to 
the Quick Setup Guide provided for connections. 

If you have questions, service needs, or require technical assistance related to the use of your Sony TV even 
after you read this operating instructions manual, contact the following:

http://www.sony.com/tvsupport or call 1-800-222-SONY (7669)

http://www.sony.ca/support or call 1-877-899-SONY (7669)

• Check the input selection by pressing the INPUT button. You may be watching the wrong input. 
• If you cannot hear sound from the TV, you may have accidentally pressed the MUTING button on your 

remote control; press the MUTING button again or press VOL + to deactivate muting.

• If the remote control is not functioning properly, the batteries may be installed incorrectly or may be low or 

an object or light may be interfering with the remote control.

• To reset the TV to factory default settings:

Turn on the TV.

Press and hold down the 

V button on the remote, press the POWER button on the TV set. (The TV 

will turn itself off, then back on again.)

Release the 

V button when the TV is turn on.

WARNING: The factory reset will clear all of your customized settings including the Parental Lock setting.

When the Password is lost or cannot remember, enter the master password: 4357. This password clears your 
previous password and allows you to enter a new password.

No picture

• Check the Power Saving settings (see page 36).

Cannot receive any 
channels

• Make sure the power cord is connected securely.
• Turn on the power of the TV.
• Check cable/antenna connections.
• Make sure the Signal Type setting is correct for your TV signal source.

TV is locked to one channel • Perform Auto Program to add receivable channels that are not present 

in the TV’s memory (see pages 16 and 32).

Cannot receive or select 
channels

• Perform Auto Program to add receivable channels that are not present 

in the TV’s memory (see pages 16 and 32).

• To receive or select cable channels, make sure that Signal Type in the 

Channel settings is set to Cable (see page 32). To receive or select 
UHF channels over an antenna, make sure Signal Type is set to 
Antenna.

The TV turns off 
automatically

• Check if Sleep Timer is activated (see page 37).
• Check PC Power Management in the Eco settings (see page 36).
• Check Idle TV Standby in the Eco settings.

No picture from some video 
sources 

• Check the connection between the optional video equipment and the TV.
• Press INPUT on the remote control (see page 21).