Sony bravia kdl-37v40xx User Manual

 GB

aerial connection
No digital or analogue channels were found. 

Check all the aerial/cable connection and then 

press   to start auto-tuning again.

When the Programme Sorting menu appears on 

the screen, follow the steps of  “Programme 

Sorting” (page 23)
If you do not change the order in which the 

analogue channels are stored on the TV, go to 

step 4.

Press MENU to exit.
The TV has now tuned in all the available 

channels.

~
When a digital broadcast channel cannot be received, or 

when selecting a region in which there are no digital 

broadcasts the time must be set after performing step 3.

Press .

Press 

F

/

f

 to select “Scan Type”, then press 

g

 

to select “Quick Scan” or “Full Scan”, then press 

.

"Quick Scan" : channels are tuned according 

to the cable operator information within the 

broadcast signal. 

Recommended setting for "Frequency", 

"Network ID" and "Symbol Rate" is "Auto".

This option is recommended for fast tuning 

when supported by your cable operator. 

If the "Quick Scan" does not tune, please use the 

"Full Scan" method below.

"Full Scan" : All available channels are tuned 

and stored. This procedure may take some time.

This option is recommended when "Quick 

Scan" is not supported by your cable provider.

For further information about supported cable  

providers, refer to support web site: 

http://support.sony-europe.com/TV/DVBC

Press 

G

/

g

/

f

 to select “Start”.

The TV starts searching for channels. Do not 

press any buttons on the TV or remote.

~
Some cable providers do not support “Quick Scan”. If no 

channels are detected using “Quick Scan”, perform “Full 

Scan”.

~
Do not remove the Table-Top Stand for any reason other 

than to wall-mount the TV.

010COV.book  Page 7  Friday, July 4, 2008  12:56 PM