Sony bravia kdl-32d26xx User Manual

 GB

Press 

F

/

f

 to select the country/region in 

which you will operate the TV, then press 

.

If the country/region in which you want to use the 
TV does not appear in the list, select “-” instead of 
a country/region.

Before you start auto-tuning the TV, insert 
a pre-recorded tape into the VCR 
connected to the TV (page 4) and start play 
back.

The video channel will be located and stored on 
the TV during auto-tuning.
If no VCR is connected to the TV, skip this step.

Press .

Press 

F

/

f

 to select “Antenna” or “Cable”, 

then press 

.

If you select “Cable”, the screen for selecting the 
scan type appears. See “To tune the TV for Cable 
connection” (page 6).
The TV starts searching for all available digital 
channels, followed by all available analogue 
channels. This may take some time, so do not 
press any buttons on the TV or remote while 
proceeding.
If a message appears for you to confirm the aerial 

connection
No digital or analogue channels were found. 
Check all the aerial/cable connection and then 
press 

 to start auto-tuning again.

When the Programme Sorting menu 
appears on the screen, follow the steps of 
“Programme Sorting” (page 26).

If you do not change the order in which the 
analogue channels are stored on the TV, go to 
step 5.

Press MENU to exit.

The TV has now tuned in all the available 
channels.

~

When a digital broadcast channel cannot be received, or 
when selecting a region in which there are no digital 
broadcasts in step 4 (page 6), the time must be set after 
performing step 5.

 press 

.

Press 

F

/

f

 to select “Quick Scan” or “Full 

Scan”, then press 

.

"Quick Scan" : channels are tuned according to 
the cable operator information within the 
broadcast signal. 
Recommended setting for "Frequency", "Network 
ID" and "Symbol Rate" is "Auto".
This option is recommended for fast tuning when 
supported by your cable operator. 
If the "Quick Scan" does not tune, please use the 
"Full Scan" method below.
"Full Scan" : All available channels are tuned 
and stored. This procedure may take some time.
This option is recommended when "Quick Scan" 
is not supported by your cable provider.
For further information about supported cable  
providers, refer to support web site: 
http://support.sony-europe.com/TV/DVBC

Press 

G

/

g

/

f

 to select “Start”.

The TV starts searching for channels. Do not press 
any buttons on the TV or remote.

~

Some cable providers do not support “Quick Scan”. If no 
channels are detected using “Quick Scan”, perform “Full 
Scan”.

~

Do not remove the Table-Top Stand for any reason other than 
to wall-mount the TV.

Auto Start Up 

Language 

Country 

Select:

Confirm:

Back:

Back: 

Start:

Cancel:

MENU 

Do you want to start automatic tuning?

010COV.book  Page 6  Friday, July 13, 2007  5:05 PM