Sony CCD TRV 64 E User Manual

Mains

Battery pack

12 V or 24 V car battery

Supplied AC power adaptor

Battery pack NP-F530 (supplied), NP-F730,
NP-F930

Sony car battery charger DC-V515A

To remove the connecting plate
The connecting plate is removed in the same way as the battery pack.

WARNING
The mains lead must only be changed at a qualified service shop.

PRECAUTION
The set is not disconnected from the AC power source (mains) as long as it is connected
to the mains, even if the set itself has been turned off.

Notes on the VTR/CAMERA lamp
• The VTR/CAMERA lamp will remain lit for a while even if the unit is unplugged

after use.  This is normal.

• If the VTR/CAMERA lamp does not light, disconnect the mains lead.  After about

one minute, reconnect the mains lead.

You can choose any of the following power sources for your camcorder: battery pack,
the mains and 12/24 V car battery.  Choose the appropriate power source depending on
where you want to use your camcorder.

Note on power sources
Disconnecting the power source or removing the battery pack during recording or
playback may damage the inserted tape.  If this happens, restore the power supply
again immediately.

(1) Connect the mains lead to the mains.
(2) Slide the connecting plate down into the guides at the rear of the camcorder

until it clicks.