Sony bvm-14e5e User Manual
42
Chapter 2 Menus
Structure of the SET UP Menu
[C]
/ SYSTEM CONFIGURATION Menu
[C4]
Setting the Channel Selection Method and Power-
Up Conditions — SYSTEM CONFIGURATION Menu
Up Conditions — SYSTEM CONFIGURATION Menu
Overview
The SYSTEM CONFIGURATION menu is used for
the following settings:
the following settings:
(1) Channel number entry method
Select a method to enter channel numbers using the
ten-key pad, from two options.
Select a method to enter channel numbers using the
ten-key pad, from two options.
(2) Power-up condition
This menu sets the condition of the monitor when the
MAIN POWER switch on the rear panel is switched
on.
This menu sets the condition of the monitor when the
MAIN POWER switch on the rear panel is switched
on.
(3) Power-up input channel
Specify the channel to be selected automatically when
the power is turned on.
Specify the channel to be selected automatically when
the power is turned on.
(4) Time from power-up until degauss
If several monitors are turned on at the same time and
all start degaussing at the same time, there will be a
very large current draw on the power supply for a few
moments. To prevent this, the delay time between
power-up and degaussing can be set for each monitor
independently.
If several monitors are turned on at the same time and
all start degaussing at the same time, there will be a
very large current draw on the power supply for a few
moments. To prevent this, the delay time between
power-up and degaussing can be set for each monitor
independently.
(5) AFC time constant
(6) Residual subcarrier detection (when using the
BKM-24N/25P)
It is possible to detect residual subcarrier signals from
phase change by setting the adaptor’s residual
subcarrier switch on.
BKM-24N/25P)
It is possible to detect residual subcarrier signals from
phase change by setting the adaptor’s residual
subcarrier switch on.
(7) Auto chroma control (ACC) (when using the
BKM-27T)
BKM-27T)
(8) Holding the current contrast/brightness setting
after white balance adjustment
after white balance adjustment
(9) Making a shortcut to a white balance
adjustment menu
Make the [F2] key a shortcut key to display the
COLOR TEMP ADJ MANUAL menu. This allows
you to jump directly to the MANUAL menu display
corresponding to the color temperature setting (STD/
COL 1/COL 2) for the currently displayed image.
adjustment menu
Make the [F2] key a shortcut key to display the
COLOR TEMP ADJ MANUAL menu. This allows
you to jump directly to the MANUAL menu display
corresponding to the color temperature setting (STD/
COL 1/COL 2) for the currently displayed image.
INPUT CONFIGURATION C1
REMOTE C2
PASSWORD C3
SYSTEM CONFIGURATION C4
ON SCREEN SET C5
ALIGNMENT C6
EXTEND MENU C7
INPUT SELECT
STANDBY MODE
DEFAULT CH
DEGAUSS DELAY
AFC TIME
RESIDUAL SC SW
ACC SW
CONT/BRT HOLD
COL TEMP SHORT-CUT
Level 1
Level 2