Sony CCU-TX50P User Manual

Function and Location of Parts and Controls

5

a Camera number sheet/tally indicator
Lights red when the red tally signal is input (e.g. when 
the video signal from the video camera connected to the 
CCU-TX50/50P goes on air). When the CALL button 
on the unit or RCP-D50 remote control panel is pressed, 
the indicator lights red if it is not lit, and goes off if it is 
lit.
The indicator lights green when the green tally signal is 
input.
Attach the supplied number sheet here to indicate the 
camera number.

b POWER switch/CAM (camera) and MAIN 

The POWER switch turns on or off the power supply to 
the entire camera system, including the CCU-TX50/
50P, the video camera, and the remote control unit 
connected to the REMOTE connector on the CCU-
TX50/50P.
The MAIN and CAM indicators light when the POWER 
switch is turned on.
The CAM indicator goes off when the power is turned 
off by the CAM PW button on the remote control panel.

If the fan in the CCU-TX50/50P stops, the MAIN 
indicator will flash simultaneously to warn you of the 
abnormal condition. If this occurs, turn the POWER 
switch off immediately and contact Sony service 
personnel.

c CABLE ALARM indicators

OPEN: Lights when no triaxial cable is connected to 
the CAMERA connector on the rear panel of the 
CCU-TX50/50P, or when the load current is 
extremely low even when a camera cable is connected.
SHORT: Lights when there is a current overflow in 
the triaxial cable.

d INCOM (intercom) input/output/setting section
INCOM (intercom) connector (XLR, 5-pin)
Connects a headset.

INCOM level control
Adjusts the input level of the headset.

ON: Turns on the headset microphone.

a Camera number sheet/tally indicator

b POWER switch/CAM and MAIN indicators

c CABLE ALARM indicators

d INCOM input/output/setting section