Sony cd-cx427 Manual

d

8C-KCG-912-01
011120ATM-OX

M5 

×

 6 mm

M5 

×

 6 mm

×

 5

×

 2

×

 2

×

 2

SUPPLIED MOUNTING HARDWARE FOR
INSTALLATION → A

The installation scenario described in this manual
assumes that you have a typical car. If your specific car
requires any adjustments or modifications, consult your
nearest AIWA car audio dealer.

• This unit is designed for negative-ground, 12-V DC

operation only.

• Before starting installation, make sure the ignition switch

is set to OFF and disconnect the ground terminal of the
car battery to avoid short-circuiting.

• Install the unit where it will not hamper the operation of

the vehicle.

• Install the unit where it will not injure the passenger if

there is a sudden stop, like an emergency stop.

• Avoid installing the unit where it would be subject to high

temperatures caused by direct sunlight or hot air from
the heater, or where it would be subject to dust, dirt or
excessive vibration.

• Use only the supplied mounting hardware, for a safe

and secure installation.

PREINSTALLATIONS → B

If there is installation hardware for another receiver
already in the dashboard, it must be removed.
Before installing the unit in the dashboard
Remove the trim plate from the unit 

→

 

1

• FLAP (flap panel)-type model  Remove the trim plate

a

 by pushing the side of the plate in the direction of the

arrow.

• FIX (fixed panel)-type model  Remove the trim plate

a

 by pushing the upper and lower parts of the plate in

the direction of the arrow.

• As for the DFP (Detachable Front Panel) -type model,

the trim plate is separately packed at the factory.

→

2

Insert the levers 

8

 along each groove on both sides of

the unit to unlock the installation sleeve 

1

 and pull the

sleeve to detach it from the unit.

BASIC INSTALLATIONS → C

Installation in the dashboard
Note that the Installation shown is a typical example.
For some car types you may need to make adjustments
or modifications to install the unit. If your car is of such
type, consult your nearest AIWA car audio dealer.

Mounting-angle adjustment
The mounting angle should be 30 degrees or less from
horizontal.

→

D

Be sure to use the supplied screws 

9

 shown

in 

A

 to attach the mounting brackets 

M

 (not

supplied).