Sony CDX-3100 Manual
5
EN
Actual total number:
SONY CDX-3100 (
E
,S,C) 3-856-896-21(1)
Attaching the Front Panel
Apply the right side of the front panel to the
unit by attaching part A of the front panel to
part B of the unit as illustrated, then swing
the left side into the unit until it clicks.
unit by attaching part A of the front panel to
part B of the unit as illustrated, then swing
the left side into the unit until it clicks.
Notes
•
Make sure that the front panel is the right way up when
attaching it to the unit as it cannot be attached upside
down.
attaching it to the unit as it cannot be attached upside
down.
•
Do not press the front panel hard against the unit when
attaching it to the unit. It can easily be attached by
pressing it lightly against the unit.
attaching it to the unit. It can easily be attached by
pressing it lightly against the unit.
•
When you carry the front panel with you, put it in the
supplied front panel case.
supplied front panel case.
•
Do not press hard or give excessive pressure to the
display window of the front panel.
display window of the front panel.
•
Before removing the front panel, be sure to turn the
power off. However, if you press the RELEASE button to
detach the panel while the unit is still turned on, the
power will automatically turn off in order to protect the
speakers from being damaged.
power off. However, if you press the RELEASE button to
detach the panel while the unit is still turned on, the
power will automatically turn off in order to protect the
speakers from being damaged.
•
Do not expose the front panel to direct sunlight, heat
sources such as hot air ducts or leave it in a humid place.
Never leave it on the dashboard etc. of a car parked in
direct sunlight where there may be a considerable rise in
temperature inside the car.
sources such as hot air ducts or leave it in a humid place.
Never leave it on the dashboard etc. of a car parked in
direct sunlight where there may be a considerable rise in
temperature inside the car.
Caution Alarm
If you turn the ignition key switch to the OFF
position without removing the front panel, the
caution alarm will be activated, and a beep
tone will be heard for a few seconds (only for
cars with an accessory position on the ignition
key switch).
position without removing the front panel, the
caution alarm will be activated, and a beep
tone will be heard for a few seconds (only for
cars with an accessory position on the ignition
key switch).
Setting the Clock
The clock has a 12-hour digital indication.
For example, setting it to 10:08
1
Display the time.
(Press the
(Press the
OFF
or
DSPL
button during
unit operation.)
2
Press the
DSPL
button for more than
two seconds.
Set the hour digits.
3
Press the SEL button momentarily.
Set the minute digits.
4
Press the
DSPL
button momentarily.
The clock activates.
Note
If the car has no accessory position on the ignition key
switch, the clock cannot be set unless the power is turned
on. Set the clock after you have turned on the radio, or
started CD playback.
If the car has no accessory position on the ignition key
switch, the clock cannot be set unless the power is turned
on. Set the clock after you have turned on the radio, or
started CD playback.
B
A
The hour digit(s) blinks.
to go back
to go forward
The minute digits blink.
to go back
to go forward
100
1000
1000
1008