Manualsbrain.com
  1. Manuals
  2. Brands
  3. Sony
  4. CDX-A360
  5. User Manual

Sony CDX-A360 User Manual

Download
Page of 96
16
Specifications
CD Player section
Signal-to-noise ratio: 120 dB
Frequency response: 10 – 20,000 Hz
Wow and flutter: Below measurable limit
Tuner section
FM
Tuning range: 87.5 – 108.0 MHz
Antenna (aerial) terminal: 
 
External antenna (aerial) connector
Intermediate frequency: 10.7 MHz/450 kHz
Usable sensitivity: 9 dBf
Selectivity: 75 dB at 400 kHz
Signal-to-noise ratio: 67 dB (stereo), 69 dB (mono)
Harmonic distortion at 1 kHz: 0.5 % (stereo),
0.3 % (mono)
Separation: 35 dB at 1 kHz
Frequency response: 30 – 15,000 Hz
MW/LW
Tuning range: 
MW: 531 – 1,602 kHz
LW: 153 – 279 kHz
Antenna (aerial) terminal: 
 
External antenna (aerial) connector
Intermediate frequency: 10.7 MHz/450 kHz
Sensitivity: MW: 30 µV, LW: 40 µV
Power amplifier section
Outputs: Speaker outputs (sure seal connectors)
Speaker impedance: 4 – 8 ohms
Maximum power output: 50 W 
× 4 (at 4 ohms)
General
Outputs: 
Audio outputs terminal (sub/rear switchable)
Power antenna (aerial) relay control terminal
Power amplifier control terminal
Inputs: 
Telephone ATT control terminal
Antenna (aerial) input terminal
AUX input jack (stereo mini jack) 
Tone controls: 
Low: ±10 dB at 60 Hz (XPLOD)
Mid: ±10 dB at 1 kHz (XPLOD)
High: ±10 dB at 10 kHz (XPLOD)
Power requirements: 12 V DC car battery 
 
(negative ground (earth))
Dimensions: Approx. 178 
× 50 × 178 mm 
(7 
1
/
8
 
× 2 × 7 
1
/
8
 in) (w/h/d)
Mounting dimensions: Approx. 182 
× 53 × 162 mm 
(7 
1
/
4
 
× 2 
1
/
8
 
× 6 
1
/
2
 in) (w/h/d)
Mass: Approx. 1.2 kg (2 lb 11 oz)
Supplied accessories: 
Card remote commander: RM-X151
Parts for installation and connections (1 set)
Your dealer may not handle some of the above 
listed accessories. Please ask the dealer for 
detailed information.
Design and specifications are subject to change 
without notice.
Troubleshooting
The following checklist will help you remedy 
problems you may encounter with your unit.
Before going through the checklist below, check the 
connection and operating procedures.
US and foreign patents licensed from Dolby 
Laboratories.
General
No power is being supplied to the unit.
• Check the connection. If everything is in order, check 
the fuse.
• If the unit is turned off and the display disappears, it 
cannot be operated with the remote commander. 
t Turn on the unit.
The power antenna (aerial) does not extend.
The power antenna (aerial) does not have a relay box.
No sound.
• The volume is too low.
• The ATT function is activated (page 7), or the 
Telephone ATT function (when the interface cable of 
a car telephone is connected to the ATT lead) is 
activated.
• The position of the fader control “FAD” is not set for 
a 2-speaker system.
No beep sound.
• The beep sound is canceled (page 11).
• An optional power amplifier is connected and you are 
not using the built-in amplifier.
The contents of the memory have been erased.
• The RESET button has been pressed.
t Store again into the memory.
• The power supply lead or battery has been 
disconnected.
• The power supply lead is not connected properly.
Stored stations and correct time are erased.
The fuse has blown.
Makes noise when the position of the ignition 
is switched.
The leads are not matched correctly with the car’s 
accessory power connector.
MPEG Layer-3 audio coding technology and 
patents licensed from Fraunhofer IIS and Thomson.
•  Halogenated flame retardants are not used in the 
  certain printed wiring boards.
•  Halogenated flame retardants are not used in 
 cabinets.
•  Paper is used for the packaging cushions.
•  VOC (Volatile Organic Compound)-free vegetable 
  oil based ink is used for printing the carton.