Sony CDX-F5550EE User Manual

Page of 40
4
Getting Started
Resetting the unit
Before operating the unit for the first time, or 
after replacing the car battery or changing the 
connections, you must reset the unit.
Detach the front panel and press the RESET 
button with a pointed object, such as a ballpoint 
pen.
Note
Pressing the RESET button will erase the clock setting 
and some stored contents.
Setting the clock
The clock uses a 24-hour digital indication.
1
Press and hold the select button.
The setup display appears.
2
Press the select button repeatedly 
until “CLOCK-ADJ” appears.
3
Press (DSPL).
The hour indication flashes.
4
Rotate the volume control dial to set 
the hour and minute.
To move the digital indication, press (DSPL).
5
Press the select button.
The clock starts and the next setup display 
appears.
6
Press and hold the select button.
The setup is complete.
To display the clock, press (DSPL). Press 
(DSPL) again to return to the previous display.
With the card remote commander
In step 4, to set the hour and minute, press 
M or m.
DEMO mode
When the unit is turned off, the clock is 
displayed first, then demonstration (DEMO) 
mode starts the demonstration display.
To cancel the DEMO mode, set “DEMO-OFF” 
in setup (page 10) while the unit is turned off.
Detaching the front panel
You can detach the front panel of this unit to 
prevent theft.
Caution alarm
If you turn the ignition switch to the OFF 
position without detaching the front panel, the 
caution alarm will sound for a few seconds.
The alarm will only sound if the built-in 
amplifier is used.
1
Press (OFF).
The unit is turned off.
2
Press (OPEN).
The front panel is flipped down.
3
Slide the front panel to the right, then 
gently pull out the left end of the front 
panel.
Notes
• Do not drop or put excessive pressure on the front 
panel and display window.
• Do not subject the front panel to heat/high 
temperature or moisture. Avoid leaving it in a parked 
car or on a dashboard/rear tray.
Tip
When carrying the front panel, use the supplied front 
panel case.
RESET 
button
1
2