Sony CDX-GT292 User Manual
15
Power requirements: 12 V DC car battery
(negative ground (earth))
Dimensions: Approx. 178
× 50 × 179 mm
(7
1
/
8
× 2 × 7
1
/
8
in) (w/h/d)
Mounting dimensions: Approx. 182
× 53 × 162 mm
(7
1
/
4
× 2
1
/
8
× 6
1
/
2
in) (w/h/d)
Mass: Approx. 1.2 kg (2 lb 11 oz)
Supplied accessories:
Supplied accessories:
Card remote commander: RM-X151
Parts for installation and connections (1 set)
Parts for installation and connections (1 set)
Design and specifications are subject to change
without notice.
without notice.
Troubleshooting
The following checklist will help you remedy
problems you may encounter with your unit.
Before going through the checklist below, check the
connection and operating procedures.
problems you may encounter with your unit.
Before going through the checklist below, check the
connection and operating procedures.
• Halogenated flame retardants are not used in the
certain printed wiring boards.
• Halogenated flame retardants are not used in
cabinets.
• Packaging cushions are made from paper.
General
No power is being supplied to the unit.
• Check the connection or fuse.
• If the unit is turned off and the display disappears, it
• If the unit is turned off and the display disappears, it
cannot be operated with the remote commander.
t Turn on the unit.
The power antenna (aerial) does not extend.
The power antenna (aerial) does not have a relay box.
No sound.
• The ATT function is activated.
• The position of the fader control “FAD” is not set for
• The position of the fader control “FAD” is not set for
a 2-speaker system.
No beep sound.
• The beep sound is canceled (page 10).
• An optional power amplifier is connected and you are
• An optional power amplifier is connected and you are
not using the built-in amplifier.
The contents of the memory have been erased.
The power supply lead or battery has been
disconnected or it is not connected properly.
disconnected or it is not connected properly.
Stored stations and correct time are erased.
The fuse has blown.
Makes noise when the position of the ignition
is switched.
The fuse has blown.
Makes noise when the position of the ignition
is switched.
The leads are not matched correctly with the car’s
accessory power connector.
accessory power connector.
During playback or reception, demonstration
mode starts.
mode starts.
If no operation is performed for 5 minutes with
“DEMO-ON” set, demonstration mode starts.
t Set “DEMO-OFF” (page 10).
“DEMO-ON” set, demonstration mode starts.
t Set “DEMO-OFF” (page 10).
The display disappears from/does not appear
in the display window.
in the display window.
• The dimmer is set “DIM-ON” (page 10).
• The display disappears if you press and hold
• The display disappears if you press and hold
(SOURCE/OFF).
t Press (SOURCE/OFF) on the unit until the
display appears.
• The connectors are dirty (page 13).
The Auto Off function does not operate.
The unit is turned on. The Auto Off function activates
after turning off the unit.
t Turn off the unit.
after turning off the unit.
t Turn off the unit.
The display disappears while the unit is
operating.
operating.
The Black Out function is set to on (page 10).
Card remote commander operation is not
possible.
possible.
If the Black Out function is activated (no lighting),
card remote commander operation is not possible
(page 10).
card remote commander operation is not possible
(page 10).
continue to next page
t